Door Boot Seal

Part Number: W10381562

Front load washer bellow door gasket seal.  This seal connects between the outer wash tub and the front bulkhead.  Grey in color.  This is a new GENUINE Whirlpool replacement part.

Brands: Amana, Maytag, Whirlpool, Inglis

Repair Stories:

List Price: $126.37
Price: $75.80 Quantity:

Replaces these part numbers: EAP3632809, PS3632809, W10290499, W10300559, 2229552, AP5607191

Door Boot Seal
Door Boot Seal Door Boot Seal
Fast Shipping
Companion Products
36 of 43 people found
this story helpful.

Parts used:
W10381562

Difficulty level:
Kinda Difficult 3/5

Time of repair:
1 - 2 hours

Tools:
T-20 torx, phillips screw driver, 1/4" nut driver. A pick tool is very helpful to remove and install the retaining wire spring

Customer:
Fred, TX
My problem
Hole in bellows.

My Repair & Advice:

1. Unplug washer or disconnect power.

2. Turn off the water supply to the washer.

3. Remove the top cover and the console.

4. Remove the lower front access panel.

5. Open the washer door.

6. Using a small screwdriver or a pair of long-nosed pliers, pull the tension spring on the retaining wire out from around the front of the bellows, and remove the wire.

7. To remove the door switch assembly:

a) Pull the bellows off the lip of the front panel beside the door switch assembly just enough to access the switch assembly.

b) Remove the two T-20 Torx screws from the door switch assembly.

c) Pull the door switch assembly out and turn it over so that you can access the connectors.

d) Unlock the tabs and disconnect the three wire connectors from the door switch terminals, then remove the assembly.

8. To remove the bellows:

a) Remove the two T-20 Torx screws from the door switch assembly.

b) Remove the front panel from the washer.

c) Turn the bellows retaining clamp screw counterclockwise until the clamp is loose enough to remove it from around the bellows. NOTE: It may be necessary to completely remove the screw from one end of the clamp.

d) Remove the bellows retaining clamp from around the bellows.

e) Pull the bellows off the front of the tub. REASSEMBLY NOTE: When you reinstall the bellows, be sure to position the “weep holes” at the bottom. The hard part is getting the bellows in place properly and the retaining spring back in place.


Was this story helpful to you?     
*The repair stories listed on this page are for informational purposed only. They are not intended to replace an on-site diagnosis from a qualified appliance service technician. Parts Dr encourages safe repair practices.

Model Numbers: IFW7300WW00, MHWE200XW00, MHWZ400TQ03, MHWZ600WR01, NFW7300WW00, WFW9050XW00, WFW9050XW01, WFW9050XW02, WFW9150WW00, WFW9150WW01, WFW9150WW02, WFW9151YW00, WFW9250WL00, WFW9250WL01, WFW9250WL02, WFW9250WR00, WFW9250WR01, WFW9250WR02, WFW9250WW00, WFW9250WW01, WFW9250WW02