Door Latch/Switch Assembly

Part Number: 131763202

Front load washer door lock latch and switch assembly.  This is a new GENUINE Frigidaire replacement part.

Brands: Crosley, Electrolux, Frigidaire, Gibson, Kenmore, White Westinghouse

Repair Stories:

List Price: $76.72 - 29% off
Price: $54.99 Quantity:

Replaces these part numbers: 131763200, 131763245
Door Latch/Switch Assembly
Door Latch/Switch Assembly Door Latch/Switch Assembly
Fast Shipping
Companion Products
38 of 64 people found
this story helpful.

Parts used:
131763202

Difficulty level:
Very Easy 1/5

Time of repair:
0 - 15 minutes

Tools:
Phillips screw driver

Customer:
Mike, MN
My problem
Washer would tumble, but not spin fast.

My Repair & Advice:

Very easy repair!


Was this story helpful to you?     
34 of 60 people found
this story helpful.

Parts used:
131763202

Difficulty level:
Easy 2/5

Time of repair:
15 - 30 minutes

Tools:
screw driver

Customer:
Sandra, WI
My problem
Would not lock door prior to washing

My Repair & Advice:

Removed Top, unplugged switch assembly, removed and replaced. Easy to do, most time consuming part of the repair was to remove the dryer from the top of the machine to get it open.


Was this story helpful to you?     
2 of 2 people found
this story helpful.

Parts used:
131763202

Difficulty level:
Very Easy 1/5

Time of repair:
15 - 30 minutes

Tools:
phillips screwdriver.

Customer:
pedro, NJ
My problem
washer was not going into high spin, diagnosed with tech sheet(that was taped inside washer)and some internet help. verified it was the door switch. replaced and now works as it should.

My Repair & Advice:

run the diagnostic test first.


Was this story helpful to you?     
2 of 2 people found
this story helpful.

Parts used:
131763202

Difficulty level:
Very Easy 1/5

Time of repair:
0 - 15 minutes

Tools:
screwdriver and multimeter

Customer:
Victor, FL
My problem
E47 Washer would not enter in to spin mode.

My Repair & Advice:

I read the article on Parts Dr and that nailed what I needed to do in order to fix the problem. The trick was what you needed to read on the multimeter from the door lock assembly. The manual says that if you are reading approximately 1500 Ohms then its the control board. I was getting about 1100 Ohms. So what does approximately 1500 Ohms mean? After reading the article it said "Most of the failed door lock PTC's ohm out much lower than (1000-1200 ohms)." Bingo! Thats what I needed to here. I ordered the part and after recieving the part it only took 15 min to replace and I had my spin mode back. It was fast shipping and the price was a lot cheaper than going through the factory website. Excellent website. Link to the artice: http://www.partsdr.com/Repair-Help/Frigidaire-Washer-E47-Error-Code-21.cfm


Was this story helpful to you?     
*The repair stories listed on this page are for informational purposed only. They are not intended to replace an on-site diagnosis from a qualified appliance service technician. Parts Dr encourages safe repair practices.